Electronic speed controller frame mount. Fits 1.5x1.0" square tubing. Printed in heat and UV resistant PETG. Comes with 35mm m6 bolts and nuts.
Measure the hole center to center distance on your controller and choose the correct size below. Refer to photos if you are unsure of how to accurately measure hole distance.
If you have a hole distance that is not listed, send me a message through the contact page with accurate measurements and I will make one for you!
Both brackets have structural cracks and could not be use it was a waste of my money. I wouldn't buy these thing at least not from this company because i only bought 2 and both was shipped out the same way.
D
Damarkus
Worked great just had to buy longer bolts so my 72680 fardriver could be attached
T
Tyler M
Hate to see ya go
You have a month left to order so while this isn’t going to be relevant long, purchases always what’s expected. Fast shipping. Knows his stuff. Good luck with ur future endeavors. Pic for attention haha
j
jake
great controller mounts make sure u pick ur controller
A
Anonymous
The controller mounts
The controller mounts were a perfect fit, is good that it comes with hardware, although the spot where you put the nut is a bit flimsy but that’s ok. Now my controller is secure and now I don’t have to use zip ties.
